Genuine replacement Dyneema Kit (two carabiner setup) for Spiderjack versions 1, 2 and 2.1 - replaces the original Velcro connection point. The use of two carabiners assists in transition when tree climbing.
1 Items
1 Bus Days
In Stock
To install the Dyneema Kit use two 3mm Hex keys, one on each side of the Spiderjack swivel, to remove the existing Velcro connector screw.
Place the milled Dyneema (red) connector over the hole and re-insert the screw using the same 3mm Hex key. Torque down to 4 Nm or 35.4 inch pound.
Thread the ringed Dyneema sling through the milled 'red' connector, ensuring to keep the ring parallel to the eye on the swivel.
Place the Edelrid 'String' on the opposing end of the Dyneema sling and attach the completed unit to your climbing line using suitable carabiners (DMM Ultra O are a good choice). Make sure the bottom carabiner connects through the rates ring (12kN) on the Dyneema sling as well as the eye on the Spiderjack.
Add the extended 'roll ' lever with fairleads for optimum performance.
Under $250 | |
---|---|
Auckland | $6.90 |
North Island | $9.90 |
South Island | $12.90 |
Orders Over $250 | FREE* |
Orders with Rural Delivery addresses may take longer than stated to arrive.
Due to factors out of our control, Treetools is experiencing random shipping delays and supply issues that may result in some gear not being available either in-store and/or online. We apologise for any inconvenience this may cause.
NO INTERNATIONAL SHIPPING Treetools is a 'kiwi only' affair.
Find out more about Treetools Shipping and Return Policy here.
All parcels require a signature on delivery unless requested otherwise.