DMM Pinto Rig Spacer

Specifications

Width:	14 mm
Hole Ø:	10 mm

14mm aluminum spacer designed to work on the DMM Pinto Rig only (it is too wide to fit the smaller Pinto). The spacer is designed to stop the side plates from coming together when excessive load is applied - only applicable when cordage is run through the top connection holes on the pulley - that is, you do not need a spacer if the pulley is attached by carabiner. The spacer fits loosely between the two side plates. The center hole on the spacer can take hardware and soft connections up to 10 mm in diameter.

Treetools ship nationwide.